Daytona, speed pulse converter twin signals output universal

Installs on top of the stock mechanical speedo drive
cable and is M12 threaded. The converter-sensor
sends electronic pulses, allowing you to run an electronic speedometer on a bike with a mechanical driven
speedo drive. The sensor requires 12V and connects
with three 120cm wires, current, signal and ground.
The speedometer will require calibration. The stock
mechanical speedometer can still be used, when
desired, but when not in use the included cap can be
installed to weatherproof seal the drive/converter unit.
Wire length 650mm. Maximum dimensions of the inner
square cable diameter 2.54mm.